1. The problem of loosening the screws of the backboard of the hard fast door in the workshop will cause the backboard to move. Then, you need to tighten the slider screws with tools and reset them in the direction of the backboard.
2. The trip switch of the factory's quick door is invalid or the film is deformed, which will cause the normal control of the rise or fall of the quick door. Therefore, it is necessary to replace the micro switch or the contact of the device. solved.
3. The relay contact point of the hard fast door is stuck, which will cause the hard fast door to fail to start normally, so only need to replace the new relay. After using it, pay attention to the maintenance of the relay equipment, and clean up the dirt and garbage around each component in time.
4. The slider or the nut of the quick door cannot follow the rotation of the screw, so it may cause the problem that it cannot start, and you can try a solution of adding some lubricating oil.
5. The limiter transmission gear of the hard fast door in the warehouse is damaged, which will cause the limiter to fail to work normally and cause the door equipment to not be well controlled. Therefore, the transmission gear of the limiter needs to be replaced.
PDC Cutting Tips(Pieces)
PDC cutting tips are cut on the basis of PDC compound pieces, which are usually welded to Grinding discs, drills, etc. and are used in the field of floor polishing and coal Mining.
BOHONG has developed PDC series products with low wear rate and high impact resistance after a series of tests.
BOHONG has a complete product testing process to strictly control the quality, simulating the actual use of the composite sheet to test the impact resistance, wear resistance, fatigue resistance and thermal stability of the product to ensure the performance and life of the product.
Cutting Tips For Pdc,Laser Cutting Compound Tool,Pdc Cutting Tool Application,Polycrystalline Diamond Compact Cutting
Henan Bohong New Material Co., Ltd , https://www.bohongpcd.com