High Quality Anti-Dust PC U Profiles Bayer Polycarbonate Construction Accessories
Product Features: 1. Lightness Suitable thickness PC Sheets Storage: PC Sheets Installation: Step 1: Use screws to attach the base connecting profiles to the roof beams. Make sure the screws not         bend, tear or exert excessive pressure on the profile. 1. As expandable, the drilling diameter must be 1.5 times than that of the bolt. 2. Do not use gaskets made of PVC. 3. PC Sheets can't be installed too tight because there will be thermal expansion and contraction which will adversely affect the installation. Office Desk,Electric Adjustable Desk,Electric Gaming Desk,Adjustable Computer Desk Changzhou Offistyle Furniture Co., Ltd. , https://www.offistylefurniture.com
High Quality Anti-dust PC U Profiles Bayer Polycarbonate Construction Accessories
2. Graceful appearance
3. The same with PC sheet on physical property
4. Good seal ability
5. Easy installation
6. Temperature resitance range: -40 to 120°c.
7. Weather proof
8. Flame resistance: B1 grade
9. Environment friendly
Polycarbonate Characteristics:
No.
Characteristics
Unit
Data
1
Impact Strength
J/m
850
2
Light Transmission
%
85
3
Specific Gravity
g/cm3
1.2
4
Coefficient of Thermal
mm/m °c
 0.065
5
Service Temperature
 °c
 -40 to +120
6
Heat Conductivity
 W/m2°c
 2.3-3.9
7
Tensile Strength
 N/mm2
>60Â
8
Flexural Strength
 N/mm2
100Â
9
Modulus of Elasticity
 MPa
2400Â
10
Tensile Stress at Break
 MPa
>65Â
11
Elongation at Break
 %
100Â
12
Specific Heat
 kj/Kgk
1.17Â
13
Heat Deflection Temperature
 °c
 140
14
Effect of Soundproof
 dB
3-4
PC Profile Details:
PC-U: 4mm/6mm, 8mm/10mm
PC-H: 4mm/6mm, 8mm/10mm
PC-UP & DOWN SNAP CONNECTER: 4mm-10mm
Advantage
Same material as the sheets, making the construction look more beautiful & harmony.
Application
To connect polycarbonate sheets together and prevent dust inside the sheets.
Professional PC Accessories: PC "H" connecter, PC "U" edge, PC snap (PC cap), ....
Loading:
Stored on flat surfaces or wooden bearers with 100mm minimum bearing surface, placed at centre not exceeding 1m.
Make sure the place where you stored is dry, shaded and well ventilated area.
Use an opaque cover (not under flexible PVC coverings), tightly secured, protecting from wind, rain and sun.
Don't store under direct sunlight or without shelter from rain. Indoors torage is always preferable.
Â
Step 2: Place the sheet on top of the base profile support edges, with the side covered by the printed          protective film facing upwards.
Â
Step 3:Â Slide the base under the sheet and attach it to the beam.
Step 4: Place the side spacer profile onto the roof beam and attach the cap to the base by hammering         into place with a rubber mallet.
Kindly Remark: