First, the trap of the old selection criteria problems: Hongfeng that in the Royal Chemical Industry Co., Ltd. in Huddersfield and Grangemouth (England) Industrial Traps performance of the trap for up to 7 years of monitoring and experiment, a level in two Based on monitoring and testing of trap performance and fresh steam loss at producer laboratories, Royal Chemical Industry Chemical eventually modified its selection of trap items in its Engineering Design Guidelines. After the change of the new "guidance" includes trap selection table. The old selection criteria for traps have a number of drawbacks, most notably the lack of reference to the type of hydrophobic equipment and methods of hydrophobicity. The chosen trap often does not match the actual load. In particular, thermodynamic disc traps, the foundations of the old selection criteria, were mistakenly considered as universal traps by people, especially shop floor personnel. 1, steam supervisor trap life is too short. 2, trap performance has lapsed, and the actual load selection does not match. 3, as the most widely used thermodynamic disc traps, the worst energy-saving, but also with inverted bucket traps, the life expectancy is very short. 4, bimetal traps easily unstable. Second, trap selection techniques: The new "guidance" includes the trap selection table. Steam traps selection tips: 1, inverted bucket traps: As the first choice for all process loads and steam main traps, that is, all the need for steam hydrophobic occasions. 2, Float thermostatic trap: used for process hydrophobicity, especially in applications with controlled loads of up to 50 kg (50psig) or with high air contents and problems with inverted bucket steam traps. 3, the balance pressure trap: used as an important heating or heating system. 4, bimetal thermosyphon trap: for heating pipelines or heating system low temperature or frost conditions. This type of trap allows to maximize the use of sensible heat in the condensate or to prevent overheating of the product. The valve body is all stainless steel. 5. Thermodynamic Disc Traps: As an alternative to inverted bucket traps, as long as proven by previous experience, they are used with limited liability on steam supervisors and tracing pipes under pressures up to 17 kg, or as products Replace for higher vapor pressure. Not recommended because of its low energy efficiency and short lifetime (and not allowed at Huddersfield and Grangemouth). 6, in the heat less demanding occasions, with the thermostatics steam trap to replace the thermodynamic disk will increase the energy saving effect, while ensuring the service life. 7, mechanical traps (that is, inverted bucket and float trap) both in condensate load or load is small, can ensure that the steam does not contain condensed water, and thermosyphon trap in the load increases when the accumulation of condensation water.
Gate Valve
Industrial gate valves are wildly used in all type of industrial pipelines, such as power stataion, petrochemical, natual gas,water treatment ect. Pressure Seal Gate Valve, Bolt Bonnet Gate Valve, High Pressure Gate Valve and API 602 Gate Valve with ASME & DIN & EN & GOST standard are commonly used by customer. Industrial gate valve we provided can cover size from 1/2 inch to 40 inch(DN15-DN1000) matching pressure from class 150 to class 3650(PN10-PN70 0) which are suitable for operating in the working media temperature from -196℃ to 693℃, as well as material in carbon steel, stainless steel, alloy steel and duplex steel in casting material or forging material.
Gate Valve,Parallel Slide Gate Valve,Forged Gate Valve,Bw Gate Valve
Yongjia South Trading Co.,Ltd , https://www.n-lvalve.com