The problem of easy to appear on solid wood floor
>>> Link: Check the wood flooring to pay attention to three aspects 1, quilting <br> owners of the problem: the floor was only a few days, there will be a large gap between the slats. Vendor Comments: The indoor environment is too dry, and the oil is not ready in time after laying the floor. This is also the main reason for quilting. Qijia Comments: Floor cracking refers to a subtle cracking phenomenon that occurs in the floorboard itself, which is caused by improper control in the drying process and is usually a product quality issue. Before the floor was painted, many companies paid attention to the removal of the cracked board. Because the tiny cracks were difficult to discern with the naked eye, after the paint was laid in a dry environment, the gap would gradually increase and appear. Frequently, dealers mistakenly believe that “the environment has caused the floor to bulge due to the overheating of the floor and it has nothing to do with the quality of the floorâ€. This is obviously contrary to the conclusion of the mechanical analysis. Industry standards for cracking of wooden floors during the warranty period: The seam width must not exceed 0.3mm, and the seam length must not exceed 4% of the floor length. 2, from the drum, floor distortion <br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br><br> owners issues Vendor Reviews: The use of solid wood floors can absorb heat and a small amount of water. The general situation is due to too much water in the room or too much water on the floor. Experts from the Flooring Association commented: In summer, the weather is humid and poorly maintained. The solid wood floor will rise and kick up. The other situation is due to construction problems, excessive raw material moisture content and other reasons. Qi Jia Comments: To prevent the floor from the drum, deformation should pay attention to the following points: At the end of the civil works, can not be immediately laid solid wood flooring; if the room is in a humid environment, it is best to lay moisture-proof floor. 3, Qi Qiao Owner's problem: Only two months after the floor is installed, there are more than a dozen places where the joints are easily raised. Vendor Reviews: Generally there are several reasons for floor lift: a. The reserved space between the floor and the wall base is not enough when paving; b. The gap is not enough when the bridge between the room and the room is not bridged or bridged. c. The low moisture content of the floor and the dampness of the floor or the keel wood are the causes of the floor's warping. Good flooring business is not such a problem, it will only meet the standards of the floor on the market, and they will be trained installers will reserve the right space. The floor association commented: There is not enough space reserved when the bridge between the room and the room is not bridged or bridged, and the dampness of the room is also one of the causes of the lifting. Qijia Comments: The reason for the floor to be warped is also related to the fact that the floor is not completely dry. The wood is moved into the decoration site in advance to dry for a few days, so that the wood can adapt to the indoor temperature and help prevent the floor from curling up; Layer moisture-proof cotton also helps to prevent warping. 4, floor color <br> big question Owners: floor mounted when I was not at home, and so when he came home Bahrain found particularly serious color, but the floor has been Bahrain, want to change too late. Manufacturer Comments: demanding on the natural color of the wood floor of the same is not realistic. The solid wood floor must have a color difference, and the color difference is naturally present. Inevitably, this is determined by the nature of the property. It is normal that there is a slight color difference at the time of installation. Experts from the Flooring Association commented that the different parts of the same wood have different shades and textures. The heartwood is usually dark in color, and it is located inside the cross-section of the trunk. The heartwood is gradually transformed from the sapwood. The sapwood is located on the outside of the trunk. It is usually light in color and has a slight normal color difference. Qi Jia Comments: Due to the natural nature of wood, solid wood flooring inevitably has color differences. The tree growth environment, such as the difference in soil, temperature, and the age of the trees, the location of the tree sections when they were taken, the different sections, and other natural causes, caused the color difference of the plates. If you find out beforehand that you can pick out the floorboards, separate the shades of color, spread them in two rooms, or place the plates with serious color differences in the place where furniture is to be placed. Of course, the color difference is very serious before the installation can also be proposed to the factory, the appropriate change. 5, paint film peeling, cracking, wrinkling <br>owner problems: six months after the installation of the floor, the home floor paint film peeling, cracking, wrinkling. Vendor Comments: When cleaning the floor, it may be possible to use cleaners that contain alkalinity, and the paint contains acidic components that meet each other and undergo chemical changes that can cause paint corrosion, peeling, and other phenomena. Flooring Association Comments: Before the wooden floor paint, the water content of the floor is too high (moisture content greater than 12%), due to high moisture content, although the surface coated with paint, when the external environment changes, causing internal moisture to evaporate inside the wood, Changes in the internal stress of the wood, resulting in uneven force, resulting in coating cracking, spalling and other serious quality accidents. Qi Jia Comments: In the beginning to choose the floor did not pay attention to the good, the floor of the water content is too high, too low can cause the paint film crack or peeling. The paint film toughness of the paint is also very important, if the toughness can not meet the natural wet shrinkage change of wood, resulting in the film cracks wrinkles; in the initial purchase of the floor to pay attention to this problem, paint and plate together inappropriate, paint film The toughness, moisture content and other major issues, so as to avoid problems after installation. 6, floor pests, dead section <br><br><br><br><br><br><br> problem: the floor before the installation of large and small insects found on the floor, although the floor company said the locust has died, the insects will no longer develop, but psychologically still uncomfortable . Vendor Reviews: Solid wood flooring is made from natural wood, and the appearance of liveness and color differences on the surface is normal. Flooring Association Comments: This is also the natural difference between solid wood flooring and composite flooring, not too demanding, first floor products allowed to have ≤ 10mm of live joints and direct dead ≤ 3mm exist (according to the length of the floor allows 1 - 3 festivals). Qi Jia Comments: The surface has wormholes, cracks, decay, blue, dead and other defects, according to the laying of the construction needs, or shortened, or sawed in half, take its available to go to its defects. Floor acceptance paint room interior decoration space furniture Sliding Fire Doors,Fire Rated Wood Doors,Fire Rated Steel Door,Fire Roller Shutter Foshan QI'AN Fireproof Shutter Doors Co., Ltd , https://www.qianfiredoors.com
Experts from the Flooring Association commented that abnormal environmental factors such as high temperature and low humidity, sun exposure, and long-term wind (such as air conditioners) caused the floor to shrink excessively, and the lack of humidification measures was the main cause of quilting.