Do you know how to set up and use the empty dot function of the LED large screen software? Do you know how to use the empty dot function of the LED large screen software?
1. First determine the number of module draw points
Observe the number of ICs and pixels of a group of data in the module, and then use the following formula to calculate:
Number of sweep points per sweep = number of ICs * number of IC output pins / number of lights per pixel-actual pixels / scanning method
The number of lights per pixel is 3 for full-color real pixels and 4 for full-color virtual
For example, a full-color real pixel module with 30X16, 4 scans and 1 set of data. The driver IC is MBI5024 (16 output pins), and the number of ICs is 24. The calculation is as follows:
24 * 16/3-480/4 = 8, then each sweep point is 8
2. Software settings
â‘ , open the software, enter the control LED screen-screen management-configure the selected screen parameters, select the smart settings button, a dialog box appears.
â‘¡ Select the empty point setting, enter the empty point setting window, enter the number of empty points per sweep as follows:
â‘¢, LED large screen empty point button, other smart setting wizards can be set according to normal settings. When the intelligent setting guide 7, press the normal point. If there is no flash on the screen, click the empty point button on the software until it appears Flashing and then tracing according to normal conditions, in turn, until the tracing is completed.
307 Bore Type Thread Insert
307 Bore Type Thread Insert,Threaded Hole Insert 307 Self Tapping,307 Type Self-Tapping Thread Insert,307 Thread Insert
Shenyang Helisert Technology Co., Ltd , https://www.helisert.com