Dry gas cabinet installation construction method
Kitchenware Sets,Silicone Kitchen Cooking,Cookware Set,Best Cookware Sets BOHAO ENTERPRISE CO., LTD , http://www.yj-bohao.com
2. Place the upper platen in position.
3. Lay the base film on the foundation. There are several flange connection points on the base film, and the point is aligned with the foundation embedded flange and punched and then fixed on the flange (the installation personnel shall not wear sharp objects when installing the film, and need to take off the shoes or wear rubber shoes to enter ).
4. Place the inner membrane on the already installed base film and place the outer membrane on the already placed inner membrane. Take care not to scratch it. Place the boundary of the intimal outer membrane evenly on the embedded part (requiring manual alignment), check the dimensional deviation, and make some adjustments.
5. Lay the rubber seal on the embedded part of the base. The interface of the seal is glued with a special glue.
6. After the position is completed, the bottom film, the inner film and the outer film are punched together with a punch. When punching, first press the two ends of the pressure plate, fix the membrane, and then empty all the space and then fix the bolts.
7. Install constant pressure gas pipe, constant pressure control cabinet needs to be more than 10 meters away from the tank, otherwise it should use explosion-proof gas pump. Connect the voltage regulator system and detection system (this section is installed by professionals, and no specific description is provided).
8. Install the safety valve. If it is a water-sealed type, add antifreeze to the marking position.
9. Start the system.
10. Check and fill the inside and outside membranes with air. Check the leaks evenly with the leaking liquid to check for leaks. Check for leaks and handle them.